Dell EMC PowerEdge M640 - Installing the Processor into a Processor and Heat Sink Module

Figure 31. Loosening the processor bracket
3. Lift the bracket and the processor away from the heat sink, and place the processor connector side down on the processor
tray.
4. Flex the outer edges of the bracket to release the processor from the bracket.
NOTE: Ensure that the processor and the bracket are placed in the tray after you remove the heat sink.
Figure 32. Removing the processor bracket
Next steps
Install the processor and heat sink module
Installing the processor into a processor and heat sink module
Prerequisites
Follow the safety guidelines listed in Safety instructions.
40
Installing and removing system components