Figure 43. Removing the storage controller card
Next steps
Install the storage controller card.
Installing the storage controller card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Align the slots on the edge of the storage controller card with the tabs on the support bracket.
CAUTION: To prevent damage to the storage controller card, you must hold the card only by its edges.
2. Lower the storage controller card onto the connector on the system board.
3. Using the Phillips #2 screwdriver, tighten the retention screws on the drive backplane cable connector to secure the card to
the system board.
Installing and removing system components
51
To Next Page
Loading...
