Dell EMC PowerEdge M640 - Optional Microsd or Vflash Card; Removing the Internal Micro SD Card; Installing an Internal Micro SD Card

Next steps
1. Follow the procedure listed in After working inside your system.
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Optional MicroSD or vFlash card
Removing the internal micro SD card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
Locate the micro SD card slot on the internal dual SD module (IDSDM), and press the card to release it from the slot.
NOTE: Temporarily label each micro SD card with its corresponding slot number before removal. Reinstall the micro SD
cards into the corresponding slots.
Figure 49. Removing the internal MicroSD card
Next steps
Install internal micro SD card
Installing an internal micro SD card
Prerequisites
Follow the safety guidelines listed in Safety instructions.
NOTE: To use an micro SD card with your system, ensure that the Internal SD Card Port is enabled in System Setup.
Steps
1. Locate the micro SD card connector on the internal dual SD module. Orient the micro SD card appropriately and insert the
contact-pin end of the card into the slot.
56
Installing and removing system components