NOTE: Ensure that you do not push the battery holder more that 3.2 millimeters or you might risk damaging the
part.
b. Hold the battery with the "+" sign facing the positive side of the battery connector.
c. Insert the battery down into the connector and push the positive side of the battery until the battery snaps into place.
Figure 48. Installing the system battery
Next steps
1. Install the following:
a. drives
b. air shroud
c. drives
2. Follow the procedure listed in After working inside your system.
3. Enter the System Setup to confirm that the battery is operating properly.
4. Enter the correct time and date in the System Setup's Time and Date fields.
5. Exit the System Setup.
6. To test the newly installed battery, remove the system from the enclosure, for at least an hour.
7. Reinstall the system into the enclosure, after an hour.
8. Enter the System Setup and if the time and date are still incorrect, see the Getting helpsection.
Optional internal USB memory key
NOTE: To locate the internal USB port on the system board, see the System board jumpers and connectors section.
Replacing optional internal USB memory key
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Locate the USB port or USB memory key on the system board.
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
Installing and removing system components
55
To Next Page
Loading...
