Installing and removing system components
Topics:
• Safety instructions
•
Before working inside your system
• After working inside your system
• Recommended tools
• Removing the system from the enclosure
• Installing the system into the enclosure
• Inside the system
• System cover
• Air shroud
• Drives
• Drive backplane
• System memory
• Processors and heat sinks
• M.2 SSD module
• Network Daughter Card
• PCIe mezzanine card
• Storage controller card
• System battery
• Optional internal USB memory key
• Optional MicroSD or vFlash card
• IDSDM
• System board
• Trusted Platform Module
• rSPI card
Safety instructions
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: It is recommended that you always use an antistatic mat and antistatic strap while working on components inside
the system.
CAUTION: To ensure proper operation and cooling, all bays in the system must be populated always with a
component or a blank.
Before working inside your system
Prerequisites
Follow the safety guidelines listed in Safety instructions.
Steps
1. Turn off the system.
3
Installing and removing system components 13
To Next Page
Loading...
