Installing System Components 127
5
Using a #2 Phillips screwdriver, loosen one of the heat-sink retention
screws. See Figure 3-22.
6
Wait 30 seconds for the heat sink to loosen from the processor.
7
Loosen the other heat-sink retention screws.
8
Gently lift the heat sink off of the processor and set the heat sink aside
with thermal grease side facing up.
CAUTION: The processor is held in its socket under strong pressure. Be aware
that the release lever can spring up suddenly if not firmly grasped.
9
Position your thumb firmly over the processor socket-release lever and
release the lever from the locked position. Rotate the lever 90 degrees
upward until the processor is released from the socket. See Figure 3-23.
Figure 3-22. Installing and Removing the Heat Sink
1 heat-sink retention screws (4) 2 heat sink
1
2
book.book Page 127 Tuesday, March 31, 2009 5:26 PM
To Next Page
Loading...
