Installing System Components 93
Figure 3-9. Removing and Replacing a Redundant Power Supply
Installing a Redundant Power Supply
1
Verify that both power supplies are the same type and have the same
maximum output power.
NOTE: The maximum output power (shown in watts) is listed on the power
supply label.
2
Slide the new power supply into the chassis until the power supply is fully
seated and the release latch snaps into place. See Figure 3-9.
NOTE: If you unlatched the cable management arm in step of the previous
procedure, relatch it. For information about the cable management arm, see
the system’s rack documentation.
3
Connect the power cable to the power supply and plug the cable into a
power outlet.
CAUTION: When connecting the power cable, secure the cable with the
Velcro strap.
1 power supply 2 locking tab
3 cable retention bracket
1
2
3
book.book Page 93 Tuesday, March 31, 2009 5:26 PM
To Next Page
Loading...
