Need help?Do you have a question about the Dell PowerEdge R450 and is the answer not in the manual?
General| Maximum Processors | 2 |
|---|---|
| Maximum Memory | 1 TB |
| Form Factor | 1U Rack |
| Processor | Intel Xeon Scalable (3rd Gen) |
| CPU | Intel Xeon Scalable Processors |
| Memory | DDR4 |
| RAM | DDR4 |
| Storage | Up to 4 x 3.5" drives |
| RAID Support | PERC H755 |
| Network | 1 x 1GbE LOM |
| Operating System Support | Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi |
Details the components and features visible on the front panel of the server.
Details the components and features visible on the rear panel of the server.
Provides an illustration and list of internal components within the server.
Explains how to locate the system's Service Tag and other identifying information labels.
Outlines the basic steps required to unpack and set up the server.
Details the process of configuring the Integrated Dell Remote Access Controller (iDRAC).
Lists resources and methods available for installing an operating system on the server.
Specifies the essential components required for the system to power on and POST.
Explains how the system validates its configuration and reports errors.
Describes common error messages related to system configuration validation.
Covers essential safety instructions, pre-work steps, post-work steps, and recommended tools.
Details procedures before and after working inside the system, and lists required tools.
Provides instructions for removing and installing the optional front bezel.
Details the procedure for removing and installing the system cover.
Covers the removal and installation of drives, drive blanks, and drive carriers.
Provides guidelines and procedures for installing and removing system memory modules.
Details the procedures for removing and installing the processor and heat sink module.
Explains how to install and remove expansion cards and their associated risers.
Provides instructions for removing and installing power supply units (PSUs).
Details the procedure for removing and installing the system board.
Covers procedures related to the Trusted Platform Module (TPM), including upgrading.
Details the removal and installation procedures for the left and right control panels.
Identifies and describes the various connectors on the system board.
Explains the system board jumper configurations and their effects.
Provides steps to disable system and setup passwords using a jumper.
Describes the status LED indicators on the front panel and their meanings.
Explains the system health and system ID indicator codes and their conditions.
Details the indicator codes for iDRAC Quick Sync 2 and iDRAC Direct features.
Describes the LCD panel features, status, and error message display.
Explains NIC and Power Supply Unit (PSU) indicator codes and their conditions.
Details the drive status indicator codes and their meanings for each drive.
Guides on how to run Dell Embedded System Diagnostics (ePSA).
Provides information on how to contact Dell support for assistance.
Explains how to use the Quick Resource Locator (QRL) to access system information.
Describes the benefits and functionality of Dell EMC SupportAssist.
Lists additional Dell EMC documentation resources for the system.
To Next Page