Dell PowerEdge R450 User Manual

Figure 78. Removing the M.2 BOSS card from the M.2 BOSS riser
Next steps
If applicable, install a BOSS card into the M.2 BOSS riser.
Installing the M2 BOSS card into the M.2 BOSS riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Removing the M.2 BOSS riser.
Steps
1. Align and insert the M.2 BOSS card connector with the connectors on the M.2 BOSS riser.
2. Press the blue touch point on the M.2 BOSS card until it is firmly seated.
Figure 79. Installing the M2 BOSS card into the M.2 BOSS riser
78
Installing and removing system components

Dell PowerEdge R450 Specifications

General

Maximum Processors	2
Maximum Memory	1 TB
Form Factor	1U Rack
Processor	Intel Xeon Scalable (3rd Gen)
CPU	Intel Xeon Scalable Processors
Memory	DDR4
RAM	DDR4
Storage	Up to 4 x 3.5" drives
RAID Support	PERC H755
Network	1 x 1GbE LOM
Operating System Support	Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi