Installing System Components 83
Figure 3-3. Removing and Replacing the System Cover
Closing the System
1
Place the cover onto the chassis and offset it slightly towards the back of
the system, so that the two hooks on the back edge of the cover fit over the
corresponding slots on the back edge of the chassis. See Figure 3-3.
2
Slide the cover towards the front of the chassis till it snaps in position.
3
Rotate the latch release lock in a clockwise direction to secure the cover.
1 latch release lock 2 indent
1
2
book.book Page 83 Tuesday, March 31, 2009 5:26 PM
To Next Page
Loading...
