86 Installing System Components
Figure 3-5. Removing and Installing a Hot-Swap Hard Drive
Installing a Hot-Swap Hard Drive
CAUTION: Use only hard drives that have been tested and approved for use with
the SAS/SATA backplane.
CAUTION: When installing a hard drive, ensure that the adjacent drives are fully
installed. Inserting a hard-drive carrier and attempting to lock its handle next to a
partially installed carrier can damage the partially installed carrier's shield spring
and make it unusable.
CAUTION: Ensure that your operating system supports hot-swap drive
installation. See the documentation supplied with the operating system.
CAUTION: Combining SATA and SAS hard drives in the same system
configuration is not supported.
1 release button 2 hard-drive carrier handle
1
2
book.book Page 86 Tuesday, March 31, 2009 5:26 PM
To Next Page
Loading...
