Dell PowerEdge R610 - Page 96

96 Installing System Components
3 Position the internal SD module tray so the tabs on the underside of the
tray fit into the corresponding hooks on the chassis (item 3 in Figure 3-10),
then lower the opposite edge of the card into place. See Figure 3-10.
Figure 3-10. Installing the Internal SD Module
4 Connect the internal SD module cable to the connector on the control
panel board. See Figure 3-10.
5 Close the system. See "Closing the System."
6 Reconnect the system and peripherals to their power sources, and turn
them on.
1 internal SD module 2 latch
3 hooks (2) 4 cable connector on control panel
board
5 internal USB connector 6 control panel board
7 cable connector on internal SD
module
8 internal SD flash card
1
2
8
3
4
7
6
5