Rack Installation Guide 13
To change from one type of rail assembly to the other type of rail assembly:
1
Lift the blue lever on the rotating mounting bracket (see Figure 1-4).
2
Rotate the bracket and slide it up off of the two shoulder standoffs.
3
Continue to rotate the bracket 180 degrees until you can set the notches
back over the shoulder standoffs.
4
Rotate the bracket in the opposite direction until the bracket clicks into
place.
Figure 1-4. Changing the Position of the Rotating Mounting Bracket
1 mounting-bracket flange
(RapidRails version shown)
2 rotating bracket 3 release lever
4 shoulder standoffs (2) 5 notches (2)
1
43
5
2
To Next Page
Loading...
