Rack Installation Guide 23
Figure 1-10. Orientation for the Left or Right Cable-Management Arm Ramp Assembly
2
Fit the latch of the ramp assembly on the ramp assembly bracket, located
on the opposite side of the rack from where you attached the cable-
management arm (see Figure 1-11).
3
To slide the cable-management arm into place:
a
Locate the ramp assembly wireform guide at the bend of the cable-
management arm.
b
Lift and slide the ramp assembly wireform guide up the ramp,
stopping at the ramp assembly seating catch.
c
If you have selected the correct ramp assembly, the wireform guide will
seat correctly in the catch at the top of the ramp assembly each time
the system is cycled in the rack. Figure 1-11 shows the left ramp
assembly installed with the cable-management arm attached on the
right.
To disengage the cable-management arm ramp assembly, press the ramp
assembly release button on the ramp assembly latch and pull the ramp
assembly off the bracket (see
Figure 1-11).
1 left cable-management
arm ramp assembly
2 right cable-management
arm ramp assembly
3 metal ramp
1
2
3
To Next Page
Loading...
