Dell PowerEdge T110 II - Using the System Setup Program and UEFI Boot Manager; Choosing the System Boot Mode

PowerEdge T110 II Technical Guide 35
12 Storage
12.1 Overview
The PowerEdge T110 II supports up to  internal hard
drives. The following drive configurations are supported:
 
  add-on storage controller
  add-on storage controller
12.2 Hard Drives
Table 9 lists the supported hard drives for the PowerEdge T110 II. For the latest information on
supported hard drives, visit Dell.com.
Supported Hard Drives Table 11.
Form Factor
Capacity
Speed
Type

250GB, 500GB, 1TB, 2TB, 4TB
7.2K
SATA

2TB
5.4 K
SATA

500GB, 1TB, 2TB, 4TB
7.2 K
NL SAS

146GB, 300GB, 450GB, 600GB
15 K
SAS

200GB, 400GB
NA
SAS SSD

146GB, 300GB, 600GB, 900GB
10 K
SAS
12.3 RAID Configurations
Table 12 details the factory RAID configurations for the PowerEdge T110 II.
Factory RAID Configurations Table 12.
Factory Configuration
Non Mixed
drives, all
SATA or all
SAS
Configuration
Type
Configuration
Description
Min
HDD
Max
HDD
No Hard drive
0
NCZCBL
No controller/No hard drive
0
0
SATANo RAID
1
MSTCBL
On-board SATA Controller
1
4
SATA RAID
2a
MSTR0CBL
Embedded SATA SW RAIDRAID 0 with
2 hard drives
2
2
2b
MSTR0CBL
Embedded SATA SW RAIDRAID 0 with
above 2 hard drives
3
4
3
MSTR1CBL
Embedded SATA SW RAIDRAID 1
2
2
4
MSTR5CBL
Embedded SATA SW RAIDRAID 5
3
4