Need help?Do you have a question about the Dell PowerEdge C6220 II and is the answer not in the manual?
General| Form Factor | 2U Rack |
|---|---|
| Processor | Intel Xeon E5-2600 v2 series |
| Operating System Support | Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi |
| Memory | Up to 512GB DDR3 per node |
| Storage | Up to 24 x 2.5" hot-plug SAS, SATA, or SSD drives |
| Network | Dual 1GbE, optional 10GbE |
| Management | Dell Remote Access Controller (iDRAC7) with Lifecycle Controller |
| Number of Processors | Up to 2 per node (4 total in 2U chassis) |
| Power Supply | Redundant hot-plug power supplies |
Settings for System Power Management including performance modes and P-state.
Controls for enabled cores, frequency ratio, virtualization, and turbo mode.
Settings for memory frequency, throttling, operating mode, and voltage.
Essential safety warnings and precautions before performing system component removal or installation.
Step-by-step guide on how to open and close the system chassis safely.
Procedure for safely removing and installing cooling fans, including warnings.
Procedures for removing and installing hard drive blanks, carriers, and drives.
Procedure for safely removing and installing power supplies, noting PSU requirements.
Steps for removing and installing system boards and dummy trays.
Procedure for removing and installing processor heat sinks, including thermal grease application.
Steps for removing and installing processors, emphasizing socket handling.
Steps to remove and install expansion cards and their assemblies in 1U and 2U nodes.
Summary table of RAID card removal, installation, and cable plans for different models.
Procedure to remove and install memory modules, emphasizing cooling and handling precautions.
Instructions for replacing the system battery, including safety warnings.
Steps for removing and installing system boards, including associated components.
Procedure to remove and install power distribution boards, including cable management.
Procedure to remove and install direct backplanes for 3.5" and 2.5" hard drive systems.
Steps to remove and install front panel assemblies and individual front panels.
Identifies the essential components required for the system to complete POST.
Critical safety warnings and precautions for handling the system and its components.
Troubleshooting steps for issues encountered during system installation or peripheral connections.
Guidance for resolving system halts during startup, especially after configuration changes.
Steps to identify and resolve issues with power supplies, including fault indicators.
Checks for conditions that can cause overheating, such as removed covers or obstructed airflow.
Steps to diagnose and resolve issues related to memory configuration and module installation.
Procedure for troubleshooting hard drives, especially in RAID configurations.
Steps to check SAS controller enablement, configuration, and card seating.
Guidance for troubleshooting issues with installed expansion cards.
Steps to diagnose and resolve issues related to processor installation and seating.
To Next Page
