EasyManua.ls Logo

Dell PowerEdge C6220 II - Direct Backplane Jumper Settings

Dell PowerEdge C6220 II
349 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
342 | Jumpers and Connectors
Direct Backplane Jumper Settings
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
The function of jumpers installed on 3.5" HDD direct backplane and 2.5"
HDD direct backplane is the same. Following is an example using the
jumpers installed on 3.5" HDD direct backplane.
Figure 5-20. Jumper Installed on Direct Backplane
Table 5-3. Jumpers Installed on Direct Backplane
Jumper
Function
Off
On
SW1 (pin1-2)
Reserved
*Disable
Enable
SW2 (pin3-4)
Reserved
*Disable
Enable
SW3 (pin5-6)
SGPIO I
2
C Select
*Disable
Enable
SW4 (pin7-8)
MFG Test
*Disable
Enable
NOTE: The * in the table of direct backplane jumper describes the default status
and the default state is not active state.

Table of Contents

Other manuals for Dell PowerEdge C6220 II

Related product manuals