Dell PowerEdge C6220 II - Command Line Interfaces for Setup Options

118 | Using the System Setup Program
Option
Description
Save Changes and Exit
Exits system setup after saving the changes. F10 key
can be used for this operation.
Discard Changes and Exit
Exits system setup without saving any changes. ESC
key can be used for this operation.
Save Changes
Save your changes and without exiting system.
Discard Changes
Saves Discards changes.
Load Optimal Defaults
Loads optimal default values for all the setup
questions.
Load Customized Defaults
Loads Customized default values for all the setup
questions.
Save Customized Defaults
Saves all setup questions’ current values as
Customized default.
Command Line Interfaces for Setup options
The options of SETUP menu allow the user to control by system
configuration utility (syscfg), the utility includes in Dell OpenManage
Deployment Toolkit (DTK).
Users can use the utility as following:
 To change the SETUP option by D4 token:
./syscfg –t=D4_token_id
(Example: ./syscfg -t=0x002D to enable NIC1)
 To check token active status:
./syscfg --istokenactive=D4_token_id
(Example: ./syscfg --istokenactive=0x002D to check the token
active status of NIC1)
 To change the SETUP option thru BMC memory directly:
./ipmitool raw <command> <data>
(Example: ./ipmitool raw 0xc 1 1 3 10 106 42 120 to set IP address