Dell PowerEdge C6220 II - System Configuration Jumper Settings on the C6220 System Board341

Jumpers and Connectors | 341
System Configuration Jumper Settings on the C6220 System Board
The function of system configuration jumper installed on each C6220
system board is shown below:
Figure 5-19. System Configuration Jumpers on the C6220 System Board
Table 5-2. System Configuration Jumper on the C6220 System Board
Jumper
Function
Off
On
Service Mode
*Disable
Enable
NVRAM Clear
*Disable
Enable
BIOS Recovery
*Disable
Enable
ME Firmware Recovery
*Disable
Enable
MEDBG1
*Disable
Enable
Power Button Pass
*Disable
Enable
Jumper
Function
Pin1-2
Pin2-3
PWRD_EN
*Enable
Disable
NOTE: The * in the table of system configuration jumper describes the default
status and the default state is not active state.