Removing and Installing System Components | 301
8 Remove the screw that secures the sensor board to the hard drive cage.
See Figure 3-107.
9 Remove the sensor board from the hard drive cage. See Figure 3-107.
Figure 3-107. Removing and Installing the Sensor Board
Installing the Sensor Board for 3.5” Hard-Drive System
CAUTION: Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came with
the product.
1 Replace the sensor board into the hard drive cage. See Figure 3-107.
2 Replace the screw that secures the sensor board to the hard drive cage.
See Figure 3-107.
3 Connect the sensor board cable to the sensor board. See Figure 3-108.
4 Replace the hard drive cage into the chassis. See Figure 3-96.
5 Replace the screws that secure the hard-drive cage to the chassis. See
Figure 3-95.
To Next Page
Loading...
