Dell PowerEdge C6220 II - Cable Routing for LSI 9265-8 I Card (2 U Node)

Removing and Installing System Components | 207
11 Install the system-board assembly. See “Installing a System-Board
Assembly” on page 171.
Cable Routing for LSI 9265-8i Card (2U Node)
1 Connect the mini-SAS&SGPIO cable to the LSI 9265-8i card, and
connect the other end of the cable to the corresponding connectors on
the interposer extender for 2U node. Ensure the cables go through the
cable clip ring. See Figure 3-37.
2 Connect the mini-SAS cable to the LSI 9265-8i card, and connect the
other end of the cable to the corresponding connector on the system
board. Ensure the cables go through the cable clip ring. See Figure 3-37.
3 Connect the RAID battery cable to the BBU interposer card on the LSI
9265-8i card, and connect the other end of the cable to the
corresponding connector on the RAID battery. See Figure 3-37.
4 Connect the power cable to the interposer extender for 2U node, and
connect the other end of the cable to the corresponding connector on
the system board. See Figure 3-37.