Dell PowerEdge T110 - Installing the Chassis Intrusion Switch

Installing System Components 97
5 Remove the switch and its attached cable from the system.
Figure 3-21. Removing and Installing the Chassis Intrusion Switch
Installing the Chassis Intrusion Switch
1 Align the chassis intrusion switch with the securing bracket notch. See
Figure 3-21.
2 Slide the switch into the securing bracket notch.
3 Connect the switch cable to the INTRUSION connector on the system
board. See Figure 6-1.
4 Close the system. See "Closing the System" on page 58.
1 chassis intrusion switch 2 securing bracket notch
3 INTRUSION connector
1
2
3
Mayzie_HOM.book Page 97 Monday, August 31, 2009 9:33 PM