Dell PowerEdge T620 - Installing System Components

3
Installing System Components
Recommended Tools
You may need the following items to perform the procedures in this section:
• Key to the system keylock
• #2 Phillips screwdriver
• T10 and T15 Torx screwdrivers
• Wrist grounding strap connected to ground
Following tools are required for assembling cables for a DC power supply unit (PSU), when available:
• AMP 90871-1 hand-crimping tool or equivalent
• Wire-stripper pliers capable of removing insulation from size 10 AWG solid or stranded, insulated copper wire
NOTE
: Use alpha wire part number 3080 or equivalent (65/30 stranding).
Front Bezel (Optional)
Installing The Front Bezel
1. Insert the bezel tabs into the bezel tab slots in the chassis.
2. Firmly press the top end of the bezel into the chassis until the lever locks into place.
3. Using the system key, lock the bezel.
37