Figure 15. AC PSU cabling (one of two connections identified)
Verify connections
Use iDRAC or PowerTools SHM CLI to verify that the enclosures are connected to your system.
Steps
1. To use iDRAC, go to the Storage>Enclosures view and verify that the enclosure is listed.
See the Integrated Dell Remote Access Controller User's Guide for details about using iDRAC.
2. To use PowerTools SHM CLI, run the following command:
shmcli list enclosures
See the PowerTools Server Hardware Manager Administrator's Guide for details about using these commands.
Connecting SAS and power cables
17
To Next Page
Loading...
