Installing the DC-in Adapter Port
Steps
1. Place the DC-in adapter port into the slot on the palm-rest assembly.
2. Route the power-adapter port cable through its routing guides on the palm-rest assembly.
3. Replace the M2x3 screw that secures the power-adapter port to the palm-rest assembly.
4. Connect the power-adapter port cable to the system board.
5. Install the:
a. battery
b. base cover
6. Follow the procedures in After Working Inside Your Computer.
Antenna cover
Removing the antenna cover
Steps
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
a. base cover
b. battery
c. WLAN Card
d. display assembly
3. Carefully turn the display hinges at an angle.
Disassembly and reassembly
27
To Next Page
Loading...
