Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the palm-rest and keyboard assembly and provides a visual representation of the installation procedure.
Steps
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the system board.
2. Install the display assembly.
3. Install the I/O board.
4. Install the left fan.
5. Install the right fan.
6. Install the heat sink.
7. Install the solid state drive2.
8. Install the solid state drive1.
9. Install the memory.
10. Install the battery.
11. Install the speakers.
12. Install the base cover.
13. Follow the procedure in After working inside your computer.
Removing and installing components
45
To Next Page
Loading...
