5. Slide the hard drive out of the compartment.
6. If a 2.5–inch hard drive is installed, remove the screws and lift up the drive to remove it from the hard-drive caddy.
Installing the Hard Drive
1. If a 2.5–inch hard drive is installed on the computer, place the hard drive on the hard-drive caddy and tighten the
screws to secure the hard drive.
2. Press in on the latches of the hard-drive cage and slide it inside the compartment.
3. Connect the hard-drive power supply cable.
4. Connect the hard-drive data cable.
5. Install the cover.
6. Follow the procedures in
After Working Inside Your Computer
.
Removing the Thermal Sensor
NOTE: The thermal sensor is an optional component and your computer may not ship with it.
1. Follow the procedures in
Before Working On Your Computer
.
2. Remove the cover.
18
To Next Page
Loading...
