Dell Precision T5610 - Removing the Air Tunnel; Installing the Air Tunnel; Removing the Memory

Removing the Air Tunnel
NOTE: The air tunnel is an optional component and your computer may not ship with it.
1. Follow the procedures in Before Working On Your Computer .
2. Remove:
a. cover
b. optical drive
3. Press down on the retention tab on the air tunnel and lift it from the computer.
Installing the Air Tunnel
NOTE: The air tunnel is an optional component and your computer may not ship with it.
1. Install the air tunnel in the computer chassis.
2. Mount the air tunnel module on the base and press downwards until it clicks into place.
3. Install:
a. optical drive
b. cover
4. Follow the procedures in After Working Inside Your Computer .
Removing the Memory
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a. cover
b. air tunnel (if available)
22