Dell Precision T7600 - Installing the Hard Drive; Removing the Left Cover

9. If a 2.5 inch hard drive is installed , Push the retention clips in an outward direction and lift up the drive to remove it
from the 3.5 inch hard-drive caddy.
Figure 10.
Installing the Hard Drive
1. Flex the hard drive-bracket and then insert the hard drive into the bracket.
2. Slide the hard-drive bracket into its compartment and close the hard-drive bracket clasp.
3. Install the front cover.
4. Follow the procedures in After Working Inside Your Computer .
Removing the Left Cover
1. Follow the procedures in Before Working Inside Your Computer .
2. Pull up the cover release latch on the side of the computer.
Figure 11.
3. Lift the cover upward to a 45–degree angle and remove it from the computer.
14