Dell PS4000 - Appendix F: Cisco IOS Switch Configuration

Dell EqualLogic Configuration Guide v11.3
56
console(config-if)# exit
console(config)# exit
console# copy running-config startup-config
console# exit
D.4 Disabling Unicast Storm Control
To disable port storm control on the PowerConnect 54xx switch, use the no port storm-control
broadcast enable command.
The following steps are an example of using this command to disable storm control on a single port of a
PowerConnect 5448 switch:
console# configure
console(config)# interface Ethernet g1
console(config-if)# no port storm-control broadcast enable
console(config-if)# exit
console(config)# exit
console# copy running-config startup-config
console# exit
The following steps are an example of how to disable storm control on all ports of a PowerConnect
5448 switch:
console# configure
console(config)# interface range ethernet all
console(config-if)# no port storm-control broadcast enable
console(config-if)# exit
console(config)# exit
console# copy running-config startup-config
console# exit