Dell S300 - Page 29

28 Using Your Projector
5 Laser Point the remote control at the screen, press and
hold the laser button to activate the laser light.
CAUTION: Do not look at the laser point when
it is active. Avoid directing the laser light on
your eyes.
6 Aspect Ratio Press to change aspect ratio of a displayed image.
7 Keystone adjustment Press to adjust image distortion caused by tilting the
projector (+40/-35 degrees).
8
Page up
Press to move to previous page.
NOTE: The USB cable must be connected if
you want to use the Page Up feature.
9
Page down
Press to move to next page.
NOTE: The USB cable must be connected if
you want to use the Page Down feature.
10
Keystone adjustment Press to adjust image distortion caused by tilting the
projector (+40/-35 degrees).
11 S-Video Press to choose S-Video source.
12 Video Press to choose Composite Video source.
13 Video mode The projector has preset configurations that are
optimized for displaying data (presentation slides)
or video (movies, games, etc.).
Press the Video Mode button to toggle between
Presentation mode, Bright mode, Movie mode,
sRGB, or Custom mode.
Pressing the Video Mode button once will show the
current display mode. Pressing the Video Mode
button again will switch between modes.
14 Blank screen Press to hide/unhide the image.
15
Up
Press to navigate through the On-Screen Display
(OSD) Menu items.
16
Left
Press to navigate through the On-Screen Display
(OSD) Menu items.
17
Menu
Press to activate the OSD.
THE TRUSTED SOURCE FOR PROJECTOR LAMPS AND ACCESSORIES