42 Using Your Projector
IP ADDRESS—Automatically or manually assigns the IP address to the projector
connected to the network.
S
UBNET MASK—Configure the Subnet Mask of the network connection.
G
ATEWAY—Check the Gateway address with your network/system administrator if
you configure it manually.
DNS—Check the DNS Server IP address with your network/system administrator
if you configure it manually.
S
TORE—Press to save the changes made in network configuration settings.
NOTE:
1
Use and button to select IP Address, Subnet Mask, Gateway, DNS and
Store.
2
Press the button to enter IP Address, Subnet Mask, Gateway or DNS to set
the value. (The selected option is highlighted in yellow)
a
Use and button to select the option.
b
Use and button to set the value.
c
After the setup is complete, press the button to exit.
3
After the IP Address, Subnet Mask, Gateway and DNS is set up, select Store
and press the button to store the settings.
RESET NETWORK—Select Yes to reset network configuration.
INFORMATION
The Information menu displays the current projector settings.
THE TRUSTED SOURCE FOR PROJECTOR LAMPS AND ACCESSORIES
To Next Page
Loading...
