SC4020 Storage System Drives
The SC4020 storage system supports only Dell Enterprise Plus hard disk drives (HDDs) and Dell Enterprise solid-state drives (eSSDs).
Figure 10. SC4020 Storage System Drive Indicators
Item Control/Feature Indicator Code
1 Drive activity indicator
• Blinking green – Drive activity
• Steady green – Drive is detected and has no faults
2 Drive status indicator
• Off – Normal operation
• Blinking amber (on 1 sec. / off 1 sec.) – Drive identification is enabled
• Blinking amber (on 2 sec. / off 1 sec.) – Hardware/firmware fault
• Steady amber – Drive is safe to remove
SC4020 Storage System Drive Numbering
Drives are numbered from left to right in the SC4020 storage system.
The Storage Center identifies drives as XX-YY, where XX is the unit ID of the storage system, and YY is the drive position inside the
storage system.
The SC4020 holds up to 24 drives, which are numbered from left to right starting from 0.
Figure 11. SC4020 Storage Systems Drive Numbering
About the SC4020 Storage System
17
To Next Page
Loading...
