Back-Panel Ports Connectors (per Storage Controller)
Serial connector
NOTE: Not for customer use
LED Indicators
Front panel
• One two-color LED indicator for system status.
• One single-color LED indicator for power status.
• ID button with a single-color LED indicating boot
status and pressed states
Hard drive carrier
• One single-color activity LED
• One single-color LED status indicator per drive
Storage
controller
• Two single-color LEDs per Ethernet port indicating
activity and link speed
• One dual-color LEDs per SAS connector indicating
port activity and status
• One single-color LED indicating status
• One single-color LED indicating fault
• One single-color LED for identification
Power supply/
cooling fan
Two LED status indicators for Power Supply Status, AC
Fail status, DC Fail status, and Fan Fail status
Power Supplies
AC power supply (per power supply)
Wattage 1485 W (maximum wattage: 1764 W)
Voltage 200–240 VAC (8.8A)
Heat dissipation 1764 W (6019 BTU/hr)
Maximum inrush
current
Under typical line conditions and over the entire system
ambient operating range, the inrush current may reach
45 A per power supply for 40 ms or less
Available Hard Drive Power (Per Slot)
Supported hard drive
power consumption
(continuous)
Up to 1.2 A at +5 V
Up to 0.5 A at +12 V
12
To Next Page
Loading...
