106 Adding and Replacing Parts
Coin-Cell Battery
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
1
Follow the procedures in "Before You Begin" on page 89.
2
Remove the hinge cover. See "Hinge Cover" on page 100.
3
Remove the keyboard. See "Keyboard" on page 101.
1 system board
connector
2 antenna cables (2) 3 antenna cable
connectors (2)
2
1
book.book Page 106 Friday, October 19, 2007 2:03 PM
To Next Page
Loading...
