98 Adding and Replacing Parts
Modem
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
If you ordered the optional modem at the same time that you ordered your
computer, the modem is already installed.
1
Follow the procedures in "Before You Begin" on page 89.
2
Turn the computer over, loosen the captive screws on the modem cover,
and then remove the modem cover.
3
Remove the existing modem:
a
Remove the modem screw.
b
Pull straight up on the attached pull-tab to lift the modem out of its
connector on the system board, and disconnect the modem cable.
book.book Page 98 Friday, October 19, 2007 2:03 PM
To Next Page
Loading...
