Adding and Replacing Parts 107
4
Insert a plastic scribe into the guide on the side of the coin-cell battery
compartment, and pop the battery out.
When you replace the battery, insert it at a 30-degree angle under the clip
with the positive (identified by a plus [+] symbol) side up, and then push it
into place.
Display
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE: To help prevent damage to the system board, you must remove the battery
from the battery bay before you begin working inside the computer.
1
Follow the procedures in "Before You Begin" on page 89.
2
Remove the hinge cover. See "Hinge Cover" on page 100.
3
Remove the six screws that secure the display (two on the top, two on the
bottom, and two on the back).
4
Disconnect the antenna cables from the Mini-Card.
book.book Page 107 Friday, October 19, 2007 2:03 PM
To Next Page
Loading...
