108 Adding and Replacing Parts
5
Loosen the captive grounding-wire screw.
6
Disconnect the display cable, using the pull-tab.
7
Dislodge the display cable from the display cable channel.
8
Lift the display away from the computer.
NOTICE: The standby switch is fragile and easily broken. Avoid knocking the
switch when removing and replacing the display.
1 screws (2) 2 display cable 3 display cable pull-tab
4 captive grounding-
wire screw
5 antenna cables (2) 6 standby switch
7 display cable
connector on system
board
8 display cable channel
2 3
5
14
7
8
6
book.book Page 108 Friday, October 19, 2007 2:03 PM
To Next Page
Loading...
