Steps
1. Using the alignment posts, place the left speaker on the palm-rest and keyboard assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Using the alignment posts, place the right speaker on the palm-rest and keyboard assembly.
NOTE: Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
4. Connect the speaker cable to the connector on the system board.
5. Adhere the tape that secures the speaker cable to the palm-rest and keyboard assembly.
6. Place the Mylar over the system board.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in After working inside your computer.
Removing and installing components
29
To Next Page
Loading...
