7. Remove the screw (M2x4) that secures the left-display hinge to the palm-rest and keyboard assembly.
8. Pry open the left-display hinge.
9. Remove the two screws (M2x4) that secure the Type-C port-bracket to the palm-rest and keyboard assembly.
10. Lift the Type-C port-bracket off the palm-rest and keyboard assembly.
11. Pry open the right-display hinge.
12. Lift the display assembly from the palm-rest and keyboard assembly.
CAUTION: To avoid damaging the display, do not slide the palm-rest and keyboard assembly over the display
assembly.
13. After performing the above steps, you are left with the display assembly.
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation process.
About this task
The following image(s) indicate the location of the display assembly and provides a visual representation of the installation
procedure.
38 Removing and installing components
To Next Page
Loading...
