Heat sink (integrated graphics)
Removing the heat sink (integrated graphics)
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Enter Service Mode.
3. Remove the base cover.
About this task
NOTE: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
NOTE: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your skin
can reduce the heat transfer capability of the thermal grease.
The following image(s) indicate the location of the heat sink (integrated graphics) and provides a visual representation of the
removal procedure.
Steps
1. In reverse sequential order (4>3>2>1) loosen the four captive screws (M2x2) that secure the heat sink to the system board.
2. Lift the heat sink from the system board.
Removing and installing components
43
To Next Page
Loading...
