Installing the hard drive
1. Insert the hard drive assembly into its slot on the computer.
2. Tighten the screws that secure the hard drive to the computer
3. Connect the hard drive cable to the connector on the system board.
4. Install the:
a. battery
b. back cover
5. Follow the procedure in After working inside your computer
Removing the memory module
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. back cover
b. battery
3. To remove the memory module:
a. Lift the plastic enclosure covering the top of the memory module compartment [1].
b. Pull the retention clips from the memory module until it pops up [2].
c. Remove the memory module from the connector on the system board [3].
10
To Next Page
Loading...
