Installing the memory module
1. Insert the memory module into the memory module socket.
2. Press the memory module until it clicks into place.
3. Close the plastic enclosure which covers the memory module.
4. Install the:
a. back cover
b. battery
5. Follow the procedure in After working inside your computer
Removing the WLAN card
1. Follow the procedures in Before working inside your computer.
2. Remove the:
a. back cover
b. battery
3. To remove WLAN card:
a. Lift the plastic flap which covers the WLAN card [1].
b. Remove the screw that secures the WLAN card to the computer [2] [3].
c. Disconnect the antenna cable from the WLAN card [4].
d. Remove the WLAN card from the slot on the system board [5].
11
To Next Page
Loading...
