1 release latch 2 optical drive bay
3 media card reader
6. Slide the device out through the front of the computer.
7. If you are installing a replacement device, skip to step 5 in Replacing or Adding a Media Card Reader.
If you are removing the device permanently and the drive bay is to remain empty, proceed to step 8
.
8. Disconnect the USB interface cable from the system board (see System Board Components
), and remove the cable
from the computer.
9. Install a 3.5-inch front-panel insert into the empty drive bay:
a. Holding the front-panel insert at an angle, insert one end into the drive bay opening.
b. Push the other end of the insert into the opening until it fits into place.
NOTE: To comply with FCC regulations, install the 3.5-inch front-panel insert whenever the device is permanently
removed from the computer.
To Next Page
Loading...
