1 3.5-inch front-panel insert
10. For the Vostro 220s, push the release latch down to resecure the optical drive.
11. Install the cover for the empty bay onto the bezel:
a. From the inside of the bezel, while holding the cover at an angle, insert the tab on one end of the cover into the
slot on the corresponding end of the bezel opening.
b. Lower the cover until it fits securely in the bezel opening.
1 tab 2 inside of bezel
3 cover for empty bay 4 slot in bezel opening
12. Replace the bezel (see Replacing the Bezel
).
13. Follow the procedure in After Working on Your Computer
.
14. Enter the system setup program (see System Setup Program
for instructions) and update the drive settings.
To Next Page
Loading...
