About this task
The following images indicate the location of the 3.5-inch hard drive and provides a visual representation of the installation
procedure:
Steps
1. Place the hard drive into the hard-drive bracket and align the tabs on the bracket with the slots on the hard drive.
2. Secure the two #6-32 screws securing the 3.5 in. hard drive to the bracket.
Next steps
1. Install the side cover.
2. Follow the procedure in After working inside your computer.
HDD/ODD Bracket
Removing the HDD/ODD bracket
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the side cover.
3. Remove the 3.5 in. HDD.
22
Disassembly and reassembly