Dell Vostro 400 - Hibernate Mode

36 Setting Up and Using Your Computer
To set standby mode to automatically activate after a defined period of
inactivity:
1
Click Start → Control Panel → Pick a category → Performance and
Maintenance
.
2 Under or pick a Control Panel icon , click Power Options .
To immediately activate standby mode without a period of inactivity, click
Start
→ Turn Off Computer → Stand by.
To exit from standby mode, press a key on the keyboard or move the mouse.
Hibernate Mode
Hibernate mode conserves power by copying system data to a reserved area on
the hard drive, and then completely turning off the computer. When the
computer exits from hibernate mode, the desktop is restored to the state it
was in
prior to entering hibernate mode.
To activate hibernate mode:
1
Click Start → Control Panel → Pick a category → Performance and
Maintenance
.
2 Under or pick a Control Panel icon , click Power Options .
3 Define your hibernate settings on the Power Schemes tab, Advanced tab,
and
Hibernate tab.
To exit hibernate mode, press the power button. The computer may take a
short time to exit hibernate mode. Because the keyboard and mouse do not
function in hibernate mode, pressing a key on the keyboard or moving the
mouse does not bring the computer out of hibernation.
Because hibernate mode requires a special file on your hard drive with enough
disk space to store the contents of the computer memory, Dell creates an
appropriately sized hibernate mode file before shipping the computer to you.
If the computer’s hard drive becomes corrupted, Windows XP recreates the
hibernate file automatically.