Dell Vostro A860 - Display Inverter; Display Panel Cable


3. Align the display panel with the display cover and replace the six screws.

4. Connect the display cables to the ends of the inverter board.

5. Route the cables back through their routing channels.

6. Replace the display bezel (see Replacing the Display Bezel).

7. Replace the display assembly (see Display).
Display Panel Cable

Removing the Display Panel Cable

1. Remove the display assembly (see Display).

2. Remove the display bezel (see Removing the Display Bezel).

3. Remove the display panel (see Removing the Display Panel).

4. Turn over the display panel and remove the conductive tape on the display board.

5. Disconnect the flex cable from the display board.

Replacing the Display Panel Cable


1. Connect the flex cable to the connector on the inverter board.

2. Connect the flex cable to the connector on the back of the display panel and adhere the tape back into position.

3. Replace the display panel (see Replacing the Display Panel).

4. Replace the display bezel (see Replacing the Display Bezel).

5. Replace the display assembly (see Replacing the Display Assembly).
Display Inverter

NOTE: The Display Panel cables and connectors may differ depending on the Display Panel you ordered.
1
display board connector
2
flex cable
3
conductive tape


CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.