Dell Vostro A860 - Removing the Wlan Card

Back to Contents Page
 Mini-Cards
Dell™Vostro™A840/A860ServiceManual
Removing the WLAN Card
Replacing the WLAN Card

Your computer supports one Mini-Card for WLAN.
Removing the WLAN Card

1. Follow the procedures in "BeforeYouBegin"onpage9.

2. Remove the module cover (see Removing the Module Cover).

3. Disconnect the antenna cables from the WLAN card.

4. Remove the two securing screws from the card.

5. Lift the WLAN card out of its system board connector.
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
NOTE: If you ordered a WLAN card with your computer, the card is already installed.
NOTE: Dell does not guarantee compatibility or provide support for Mini-Cards from sources other than Dell.
1
WLAN card
2
securing screw (2)
3
antenna cable connector (2)

