Installing The Optical Drive
1. Push the optical drive into the computer till it snaps into place.
2. Connect the data cable and power cable to the optical drive.
3. Install the:
– bezel
– cover
4. Follow the procedures in
After Working Inside Your Computer
.
Removing The Hard Drive
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove the:
– cover
– bezel
3. Follow the steps below to remove the hard-drive bracket:
a) Disconnect the SATA cable and power cable from the hard drive [1,2].
b) Push the blue tab on the hard-drive bracket and lift it to remove it from the computer [3,4].
13